UPDATED Gen 3 6.0 Iron Block for sale
UPDATED Gen 3 6.0 Iron Block for sale I have a Used Gen 3 6.0 iron block for sale.
was bored .030" over by LME then run
the deck has been cut .010" then run
had ARP main studs and head studs in it.
comes with the main caps.
will not ship block. i have a hoist to place the block into your vehicle.
i am in the austin area
$400 OBO
was bored .030" over by LME then run
the deck has been cut .010" then run
had ARP main studs and head studs in it.
comes with the main caps.
will not ship block. i have a hoist to place the block into your vehicle.
i am in the austin area
$400 OBO
Last edited by jdoyle; Aug 18, 2012 at 02:34 PM.
Bearings New? Can I get pics as well? Borediniraq7@Yahoo.com or 817-566-6602.
I bet it will need main bearings and I am leaning towards yes on the cam bearings but I am not positive so let me take pictures of them and post them up. I figured since it is a bare block that all of the bearings would be replaced And everything would be observed during the course of the buyer's engine build to determine what needs to be performed but I am no machinist/engine builder so I could very well have the protocol all wrong.
I should have pictures up in 4 hours.
I should have pictures up in 4 hours.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
