Serpentine pulleys for 74 vette SBC
#1
Teching In
Thread Starter
Join Date: Dec 2019
Location: Mid Minnesota
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Serpentine pulleys for 74 vette SBC
Looking for ideas on Serpentine pulleys for 74 vette SBC.
Its a friends car, and the motor is pumped to 700 HP w/Nitrous. He jumps belts frequently when close to 6,000 RPMs.
Is there any late model 80s vette engines with Factory serpentine setups that will have a tight spacing for his use?
Its a friends car, and the motor is pumped to 700 HP w/Nitrous. He jumps belts frequently when close to 6,000 RPMs.
Is there any late model 80s vette engines with Factory serpentine setups that will have a tight spacing for his use?
#3
Teching In
Thread Starter
Join Date: Dec 2019
Location: Mid Minnesota
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Rebob5, Thanks for the reply.
They look like they make pretty nice stuff.
I am simply looking to find something off a 80's -90's SBC that may fit without spending a lot on an older engine.
I think some of the Impala SS stuff may have used similar pulleys as the Corvette spacing. If the crank pulley is tough to find, I may just get LS stuff for the PS, Alt, AC, and then get Jones or ICT pulleys for the water pump and Crank.
They look like they make pretty nice stuff.
I am simply looking to find something off a 80's -90's SBC that may fit without spending a lot on an older engine.
I think some of the Impala SS stuff may have used similar pulleys as the Corvette spacing. If the crank pulley is tough to find, I may just get LS stuff for the PS, Alt, AC, and then get Jones or ICT pulleys for the water pump and Crank.