Atlanta LT1 Tuning, where to go???
#1
Teching In
Thread Starter
Join Date: Dec 2008
Location: Lubbock, TX
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Atlanta LT1 Tuning, where to go???
I bought my Camaro from onebad636 last month and want to get it Dyno tuned. Went to Vengeance today for a quote on installing 9", torque arm, and driveshaft but they said they don't tune LT1s. So, the only other shops that I've heard of around here are
Spartan Perf
Atlanta Performance and Fabrication
Red Star Performance (Oxford Ga)
If any of these have worked on your car (especially if it was an LT1) let me know your opinion.
Spartan Perf
Atlanta Performance and Fabrication
Red Star Performance (Oxford Ga)
If any of these have worked on your car (especially if it was an LT1) let me know your opinion.
#4
Teching In
Thread Starter
Join Date: Dec 2008
Location: Lubbock, TX
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
It has the 94/95 PCM conversion with a tuning cable so I could get the software and learn how to do myself. I think I'd rather have a tuner do it all at once though. Does APF have username on this board?
Trending Topics
#11
Staging Lane
Join Date: Jun 2008
Location: A bit south of Sacramento, CA
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
Atlanta Chassis Dyno can tune the car for you.
When I lived there they were the only folks I would have do performance work.
Lots of real world experience and they won't screw you on $$.
http://www.bradbrand.com/
When I lived there they were the only folks I would have do performance work.
Lots of real world experience and they won't screw you on $$.
http://www.bradbrand.com/
#13
TECH Apprentice
Join Date: Aug 2006
Location: Atlanta
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
#14
Matt, We worked things out ... no need for name calling anymore.. we now tune all cars in house, and do a great job! we will be more then happy to take care of it for you, if not there are a lot of great sponsers on this site that will help you out....
Last edited by WILL@APF; 01-22-2009 at 06:48 PM.
#17
TECH Apprentice
Join Date: Aug 2006
Location: Atlanta
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
I see that your now a sponsor.....I guess that's gonna make it kind of hard to keep up his whining over and over. You take that high road....I just hope your check don't bounce! :-)
#19
TECH Apprentice
Join Date: Aug 2006
Location: Atlanta
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
I am sure you would be happy using Atlanta Performance and Fabrication. They are knowledgeable and very reasonable on price. You can see the quality of work they do by looking at my build in the forced induction section. Good Luck!!
#20
Last edited by WILL@APF; 01-23-2009 at 10:43 AM.