amp works with 1 sub and not 2
#1
Teching In
Thread Starter
Join Date: Sep 2004
Location: Canton, MS
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
amp works with 1 sub and not 2
So here's my setup:
Audiobahn a8002T
200.0 Watt - 4.0 Ohm - 2.0 channel(s)
400.0 Watt - 2.0 Ohm - 2.0 channel(s)
800.0 Watt - 4.0 Ohm - 1.0 channel(s)
2 10" JL 10w-1
4 ohm single voice coil
125watt RMS
Ported box
Now that all of that is out of the way. Here's way happens.
hook each sub to each channel and the power light will continually fade out (along with sound) After a few times of this it'll eventually cut off and then turn back on and the sub will shoot out and then th protection light will come on.
hook 1 or 2 bridged............ same thing..
hook 1 to 1 channel and it works perfectly.
Any suggestions?
TIA
Audiobahn a8002T
200.0 Watt - 4.0 Ohm - 2.0 channel(s)
400.0 Watt - 2.0 Ohm - 2.0 channel(s)
800.0 Watt - 4.0 Ohm - 1.0 channel(s)
2 10" JL 10w-1
4 ohm single voice coil
125watt RMS
Ported box
Now that all of that is out of the way. Here's way happens.
hook each sub to each channel and the power light will continually fade out (along with sound) After a few times of this it'll eventually cut off and then turn back on and the sub will shoot out and then th protection light will come on.
hook 1 or 2 bridged............ same thing..
hook 1 to 1 channel and it works perfectly.
Any suggestions?
TIA
#3
11 Second Club
iTrader: (4)
Join Date: Oct 2005
Location: Avon Park, Florida
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
It says 4 ohm single voic coil above so i am guessing he should be fine either way if he wires them bridged or not since it would be a 2 ohm impedence when bridged. So I don't see that as the problem, it could be the amp or a bad ground or power going to the amp.