ExceSSive

iTrader: (13)

This may be a newB question...I am trying to re-wire my Line lock and my QTP E-cutout. I need some help.

1. I have a 2 wire set-up for the line lock. Does it matter that the switch on my switch plate has 2 wires? Use the outer 2? One give away the hot source but no marking on the other side.

2. I have a QTP electric cutout it has multiple wires and the switch I have only has 6? Which ones do I use and how to I re-wire this thing?

Pics
Ashtray Switch plate...top right is cutout, top left is line lock.


Cutout switch...

bmnicolosi

iTrader: (2)

The third pole on your switch should be for it to light up if it is a singlethrow switch, or if its a dual throw switch the middle is common and the two outers go with the switch in that position.

ExceSSive

iTrader: (13)

So the middle one on the line lock goes to the light? It is a ground maybe and the red feeds both or a red/power and the ground feeds both?

bmnicolosi

iTrader: (2)

if i can read it correct, it has A, B, and -. A and B go to 12v source and linelock input. Either can go to either. Then ground to -

bmnicolosi

iTrader: (2)

on second look, if its 1, 2, 3. i would say 1 and 2 to what i called a and b, and 3 to ground

ExceSSive

iTrader: (13)

Here is a diagram of the switch I just found.



A diagram of the QTP switch or a similar one.

http://quicktimeperformance.com/FAQ/...dualswitch.pdf

Could not get it in a pic...

ExceSSive

iTrader: (13)

From the 2 pics, what do I do with the 2 extra wires/connections?