ls2 bait

iTrader: (11)

anyone have them? im trying to find a place to stuff one as i dont want to put it under my air vent because then i wont be able to read it when the screens out. plus i dont want to loose my ss dash plaque.

Z28LS1camaroguy

iTrader: (3)

you can mount it on the steering column infront of the speedo and tach on the outside of the clear plastic cover, someone on here has done it and it looked awsome. but i like it where you dont want it to be thats the koolest and most perfect spot for it in my opinion.

2MuchRiceMakesMeSick

Ive seen a few people put it where it says "camaro" above the radio

ls2 bait

iTrader: (11)

ya thats were my ss dash plaque is which i dont want to loose.

anyone have dimensions of it? L x W x H?

ls2 bait

iTrader: (11)

t.t.t.

2MuchRiceMakesMeSick

I found a pic of one beside the camaro logo


Ill try to get the exact dimentions for you.

ls2 bait

iTrader: (11)

damn that looks really good but then i loose my tcs and fog light switches! this is harder than i thought it was going to be.....

ls2 bait

iTrader: (11)

i was thinking it would look really good on the drivers side pillar as well right on the corner of the dash above the ac vent. however a trim peice would need to be fabricated.

ls2 bait

iTrader: (11)

t.t.t i need dimensions if someone could please get them for me. im going to make a mock out of cardboard or the like to try diff fitments. im not going to buy one if i cant find a good place to mount it.

2MuchRiceMakesMeSick

No need to lose the tcs and fog switches.
Just relocate them


Here is a link to the LS1 scanmaster manual (the site is down right now)
http://ramchargers.com/RamNews/Trans...LS1_manual.htm

2MuchRiceMakesMeSick

I was told "Just under 4" wide x 1" high x 2.5" deep." by a vendor that sells them

ls2 bait

iTrader: (11)

thank you

Frosty

iTrader: (17)

Sorry to bump an old thread but I have just a regular Camaro so all that little plaque says is Camaro. No loss there. Could I pop that out and cut out behind that for the scanmaster? It'd be easier than relocating my fog light switch(not that it's THAT hard). Is there anything behind that plaque?

Frosty

iTrader: (17)

That's because Ramchargers is no longer in business I think.

Frosty

iTrader: (17)

Nevermind on my question. I guess I should check for myself before asking such a stupid question lol.

Here's a legit question though. How much cutting/dremeling do you have to do?