I think I installed my QTEC switch wrong...
#1
TECH Apprentice
Thread Starter
Join Date: Apr 2003
Location: Houston, TX
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
I think I installed my QTEC switch wrong...
I ran the wire from the motor up through the shifter boot, and put the switch in the ashtray. What I'm not sure of, is I ran the power wires to the harnessin front of the shifter, I can't remember what all goes there except the ashtray light. I piggybacked the positive wire with a red wire, and the negative with a black. However, I am now sure that I did something wrong. Whenever I floor it, I smell burning wires, and the ashtray light gets REALLY hot. I'm guessing I ran the power to the wrong leads. Can anyone tell me which ones I should plug it into?
#3
TECH Apprentice
Thread Starter
Join Date: Apr 2003
Location: Houston, TX
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
Re: I think I installed my QTEC switch wrong...
I just double checked where I put it (I installed it a month ago) and I ran the wires into the back of the TCS switch. I'll check on the lighter wires, thanks.