CamaroRick

iTrader: (24)

I used to work at a chevrolet dealership, before we closed i used to do allignments on my own vehicles after hours, and now ive come to a point where i need to do an allignment on the camaro. The only issue i think im going to run into is that my UMI tube kmember does not have the factory holes in it which are used my the kent more push / pull tool. I have a feeling that wherever i take it they will complain and not get it to spec. Has anyone run into this in the past?

UMI Performance

iTrader: (77)

Hello,

Yes that is a small issue and some alignment shops get confused. We use a pry bar and push on the center tube of the A-Arm. If they know what they are doing they will figure something out

Hope that helps!
Ryan

EDS01SS

iTrader: (30)

When I had mine done I just researched alot of the local shops for people that were confident with working with a tubular setup. When I was satisfied with what they were telling me then I let them work on my car.Just gotta do your homework.

CamaroRick

iTrader: (24)

im pretty sure im the only one in a 50mile radius with a tube kmember. ill give a shop a try after i get new tires

The UMI is a nice piece btw

spy2520

iTrader: (3)

using a prybar sucks *****, but you gotta do what you gotta do i guess...