Driveshaft shakes and rear end clunks???????
 

I just recentlty puton a BMR "trak-pak" (adjust. TA that connects to the SFC's., driveshaft loop) and also a Spohn Adj. panhard rod, and Spohn adj RCA's. The car is also lowered an inch and a half and has a poly transmount. Ever since these parts were put on the car, I have noticed that when I am going about 10-20 mph and go over small bumps, the rear end of the car feels like it has NO suspention. It basically sounds like a noticable "clunk" over each bump. ALSO when i go from a stoplight the car feels like the transmission hits the botton of the car on the 1-2 shift. the other shifts are ok. AND FINALLY. when slowing down at around 40-50 it feels like the drive shaft is out of balance. Like the trans and driveshaft are wobleing. somebody help me, I have to trust this thing to get to school :cheers:

o yeah and i have noticed the DS has hit the loop a few times. there is a nice clean sliver ring around the DS.

to the TOP