When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Selling my S60 rear end. Bought through Carl at CRP a couple years back. Here is the rundown.
S60
Narrowed 2 inches per side
Chromoly pinion yoke
HD yoke cap kit
2 inch long 1/2 studs but I have 3 inch long studs too
Powdercoated housing
4.10 gears
Spool with 35 spline axles
LT1 brake mounts
Also have Strange aluminum "S" cover to go with it
I did have to notch the rear end to clear the driver side caliper and I also had to cut off the weld on sway bar brackets...seems that they were welded on a little too wide and for some reason my sway bar did not want to fit right. I cut them off and used UMI's bolt on sway bar mounts and the sway bar fit just fine.
I have about $2600 in this setup and got free shipping at the time...you're looking at about $2800 to buy another new one just like this one. This rear has literally 2 miles on it, just a long trip around the block in my WS6. Then I sold that car and planned on putting it in my 94 Firehawk but my build stalled. My loss is your gain. Looking for $2000 picked up.
I am located in The Colony, which is a suburb of Dallas if you didn't already know. Thanks for looking.
02-03-2019, 10:15 PM
Strange S60 with spool and 4.10's. 
