BIGDRAGON

iTrader: (9)

I have a new 4th gen 6.0 block and would like to build a 408 fully forged to spray 200 shot of Nitrous. So many different companies make rotating assemblies,and I'm not sure who would be the best bang for the buck. Also which pistons are the best for Nitrous my goal is to be 600 HP on motor,I will be using Mast Motorsport LS3 255cc heads in this combination.
Thanks in advance.

Tuskyz28

Call Brian Nutter @ wiesco .....
He'll give you exactly what you need to get the job done at a great price.
Use callies crank/rods.

HCI2000SS

iTrader: (2)

Check out Thompson Motorsports as well

avengedws6

iTrader: (15)

Denny just have me and Dru build it. I beat up on Thompson 408s all day long. Im considering rebuilding my 370 just to keep pissin off all these 400+ cubes..... hehe.

BIGDRAGON

iTrader: (9)

PM sent Avengews6

GreatWhiteZ28

iTrader: (15)

I used a K1 Rotating assembly with Wiesco pistons in my old 408...

oscs

iTrader: (19)

K1 makes good **** for cheap. Erik@HKE uses a lot of them for budget builds. He says they hold up good.

BIGDRAGON

iTrader: (9)

I'm leaning on Callies for the crank and rods and JE pistons looking to spray 200 shot wet.

oscs

iTrader: (19)

Can't go wrong with Callie's.. Wiesco get my vote for a Pistons though.

Tuskyz28

Wiseco pistons gets my vote too.

jdoyle

iTrader: (27)

running eagle rod and wiseco piston in my 34X

oscs

iTrader: (19)

My Manley H beams were cheap and have held up to some big power. They would be fine in a 408 too