Need to Fab a intake coupler
08-20-2011, 01:27 PM
#1
On The Tree
Thread Starter
Need to Fab a intake coupler ok guys i need to fab up a intake coupler i recently swapped a LS3 into my Trans Am and now the smooth bellow doesnt fit right, i need a silicone coupler that is 4"IDx6.5"L and a 30 degree bend. i have serched all over the internet and the only ones i seem to find are 45-90 degree and there always a inch to short.
HELP!!!!
HELP!!!!
08-20-2011, 05:45 PM
#3
Banned
iTrader: (10)
Join Date: May 2006
Location: Tampa
Posts: 2,841
Likes: 0
Received 0 Likes
on
0 Posts
this isnt what your looking for but its similar and if you contact them they can make anything you want.
http://intakehoses.com/Merchant2/mer...gory_Code=SAE0
http://intakehoses.com/Merchant2/mer...gory_Code=SAE0
08-20-2011, 08:34 PM
#6
On The Tree
Thread Starter
i cant believe this is such a hard piece to find 
08-20-2011, 10:46 PM
#8
TECH Regular
iTrader: (1)
Join Date: Sep 2004
Location: Natick mass 508
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
I used a 4 in silicone hose straight and then just eyeballed the right angle at the lid and tb and cut it with a razor blade till it fit just right it worked great
08-21-2011, 09:52 AM
#9
On The Tree
Thread Starter
I can't seem to find a hump hose longer then 4" that's the piece I'd like to get. An I also considered the straight piece, I was worried about having a ugly crimp in it because it was getting bent.
