LS1TECH - Camaro and Firebird Forum Discussion - 1995 Camaro Z28

SOLD - SOLD - SOLD

I am selling my 1995 Camaro Z28. I have owned the car for the past 3 years or so. When I bought it the interior was out, engine and trans were out, and the car was black. I've done a bunch of work to this car and I hate to see it go, but I really want a C5 or C6 corvette.

Here are the spec's:
1995 Camaro Z28
355 LT1 - Stock rebuild .030 over
6 speed manual
LS1 aluminum drive shaft
3:42 Gear 10 bolt out of a 2001 SS with 29k miles
Founders Performance lower control arms
Founder Performance panhard bar
Eibach Pro Kit lowering springs
Fiberglass SS hood
K&N Cold Air Intake
C5 Z06 Wheels
Flowmaster exhaust

Some of the work that was done to this car:
All new bushings and ball joints in the front suspension
New rack and pinion
Engine is a .030 over stock rebuild
Heads have valve job, new guides, seals, and milled
Complete paint done in Sunset Orange Metallic, Paint was done by me and while it is not perfect, it looks very good. It was painted winter of 2011-2012.
Complete underside of the car was cleaned with solvent, wire wheeled where necessary and undercoated last winter (2012-2013).

The interior of the car is stock and pretty good condition. No rips in the seats, a little wear mark on the drivers bolster, but not torn. Dash pad was cracked and I repaired it and covered it with vinyl. Car has T-tops and to my knowledge they do not leak.

Look at the pictures, PM me with questions and I will respond ASAP.