1994 MB RX7 5.3L/ 6speed
05-29-2009, 03:16 PM
#1
Teching In
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: NJ
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
1994 MB RX7 5.3L/ 6speed I'm listing my project up as I really don't have that much time to finish her up. No dents, crashes, car looks good. Engine, trans, driveshaft, torque arm installed already. Harness (1998)installed and routed need to be hooked up.
Ecm was reflashed by lsx tune, harness modded to fit rx7....
4 point Bar is out of car currently.
It has an aluminum 5.3L, patriot heads(59cc), felpro.039hg, ls1 intake, fbody manifolds. Engine has approx 50K IIRC, Has plumbed fuel system using steel braided lines -8 feed/ -6 return using an aeromotive regulator. Car has a maval manual rack. The 6 speed I'm not sure of the mileage but everything moved and shifted nicely out of the car. Spec clutch, wildwood master cylinder.
Anymore info you need should be here....
Email me for interest.....
http://www.v8rx7forum.com/cars-sale/...tml#post546335
Trades might be possible.....
Ecm was reflashed by lsx tune, harness modded to fit rx7....
4 point Bar is out of car currently.
It has an aluminum 5.3L, patriot heads(59cc), felpro.039hg, ls1 intake, fbody manifolds. Engine has approx 50K IIRC, Has plumbed fuel system using steel braided lines -8 feed/ -6 return using an aeromotive regulator. Car has a maval manual rack. The 6 speed I'm not sure of the mileage but everything moved and shifted nicely out of the car. Spec clutch, wildwood master cylinder.
Anymore info you need should be here....
Email me for interest.....
http://www.v8rx7forum.com/cars-sale/...tml#post546335
Trades might be possible.....
Last edited by PETE180; 05-29-2009 at 08:44 PM.
