heres an offset question
#1
On The Tree
Thread Starter
iTrader: (16)
Join Date: Dec 2005
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
heres an offset question
I just got a set of wheels for my GTO. the problem is that they stick out approx. .300" outside the quarters and fenders. what would be the best way to get a little more backspacing out of the wheels? can I mill the back of the mounting surface? maybe have .100" taken off the face of the rotor? any advice is welcome!
#3
TECH Veteran
iTrader: (1)
I just got a set of wheels for my GTO. the problem is that they stick out approx. .300" outside the quarters and fenders. what would be the best way to get a little more backspacing out of the wheels? can I mill the back of the mounting surface? maybe have .100" taken off the face of the rotor? any advice is welcome!
I contacted AR, and told them of my idea. Long story short, they freaked out! They explained that they generally don't add any more material that what is structurally necessary, in order to manufacture a safe wheel. Therefore they STRONGLY recommended that I do not mill the center hub of the wheels.
I'm sure that your wheels might fall into this category also. For the record, what kind of wheels are they?