02 Trans am System Install [Pic's]
 

Well this is my system install. I'm highly active in this section of Ls1tech, and i would like to show you guys my install. You might recognize it from the Adriangarcia404 post done a few months ago. I'm the same person. But there has been a few modifications since then. And i finally finished the audio project!
Hope you guys enjoy!
Hope this helps people out
which are looking for a nice clean system. (i believe its clean.):secret2:
hopefully it becomes a sticky :cheers:

Thanks for One and only
Ws6kid.!

My system consist of
Alpine Type r's 6.5
http://i40.photobucket.com/albums/e2...4/ALPSPR17.jpg
In my front door's and rear seat speakers.

Alpine type r sub 10' with sub thumps stealth box.
http://i40.photobucket.com/albums/e2...04/photo-2.jpg
Great sub great low's
As you can see i also have a amp rack Thanks to kee audio!

Since my last post i blew out my DB drive series amp
and i replaced it with a infinity amp.
and i added a capacitor

Also have my IDX-305 head unit wrapped the HU mount.
http://i40.photobucket.com/albums/e2...IMG_0146-1.jpg
Another view
http://i40.photobucket.com/albums/e2...4/IMG_0096.jpg


These are pictures i took when i was installing my RCA cables.
Which are rockford fosgate
http://i40.photobucket.com/albums/e2...4/IMAG0028.jpg
http://i40.photobucket.com/albums/e2...4/IMAG0029.jpg
http://i40.photobucket.com/albums/e2...4/IMAG0030.jpg
http://i40.photobucket.com/albums/e2...4/IMAG0032.jpg
http://i40.photobucket.com/albums/e2...4/IMAG0035.jpg
The whole Install took me a whole saturday to finish and this is the Final product

http://i40.photobucket.com/albums/e2...4/IMAG0050.jpg


Great system.
It was my first install. i learned so much from it!.
Great experience.

Hope this helps out people looking for installs to grab ideas from.

Widely open to questions of any short!
also tell me how much you like my set up.
Thanks.

take out HUmount and run a piece of electrical tape over the top where the 2 pieces meet to prevent bleed through

Thanks for the advice! i was wondering how i would eliminate that bleeding problem.

shoulda sound deadend it while you were at it.

my friend told me the same thing lol.
but ill look into it!
less road noise right?

i love the humount.... kinda overkill to take out the carpet and seats tho???

took me a weekend to pull its all together.
but its worth it!
the cables dont even seem to be there
compared to my other friends rides which have cable wires popping out all over the place.:pics:

Good fix for a while. Degrease and paint with black plastic paint except for the part where the leds shine through. Looks a lot better!

Good job OP

i did the electrical tape and it fixed the bleeding problem! :burn:

no disrespect for sure your s%$s tight!
But Im good where I can do a nice install with just removing the plastics and lifting up the corner of the carpet... but sence you never run wires in bettween the seats anyhow i leave em in. All tho when i restored my old ta i ran them before the int was in and it was 20times easier.
you got a nice set up tho! Its nice to see ppl going the extra mile then doing not enough.

looks really good ! How does it sound ? I went with the Type R 6.5's not the compnents though. It is almost identical to my set up...

http://i287.photobucket.com/albums/l...e/CIMG0619.jpg

wish i had pics of my set up,, i built it and installed it before i put it away for the winter and cant get to it for a pic.
Its a type R also with a inverted set up with a 12" in the lower truck hole, its got a covered vinyl faceplate to block off seeing the mdf box...no ttops to store so i went that route.

you have any more pics of the amp rack setup?

my IDX-305 head unit raped around Humounts trans am's face plate??????

these words should not be in the same sentence together.

Thanks!

wow. all alpine i wish i had a job so i can make my whole system alpine!
infinity amp :(

but i bet your system is tight!

well i mean its really nice?

all take some tomorrow if you like.

that would be great! thanks. i'm looking into a similar setup as far as the mounting goes.

looks great!

You guys both have a very nice setup. I just installed a stealth box I got from Ian at Kee, and I just have to finish installing the rack as well. Differences with mine are a cheap amp to mount and a Kicker C12 sub. I like the setup. And I still get to store the t-tops too. I can't wait to be finished with it all.