5.3 wiring harness Wiring diagrams here!!!
The following users liked this post:
CHIVOBLING (07-14-2023)
The following 2 users liked this post by 91parkave:
CHIVOBLING (07-14-2023), ptaylo5784 (07-11-2023)
Trending Topics
#12
TECH Resident
The following users liked this post:
Frank Guerra (08-13-2024)
#14
TECH Fanatic
This is as close as i have gotten to finding the (PIN OUT) for the computer to this engine i just got! I have a LQ4 6.0 liter out of a truck(2002), any one can give me a link to it. Ive been looking for hours, and all anyone says is do a search, i did and cant find it HHHHEEEELLLPPPPP!!!!! I just want to see if i can use the stock harness, and comptuer i got with the engine.
#15
This is as close as i have gotten to finding the (PIN OUT) for the computer to this engine i just got! I have a LQ4 6.0 liter out of a truck(2002), any one can give me a link to it. Ive been looking for hours, and all anyone says is do a search, i did and cant find it HHHHEEEELLLPPPPP!!!!! I just want to see if i can use the stock harness, and comptuer i got with the engine.
I don't use all the plugs & fuse block. I cut all that off & wire up my own set up. 15 amp each +12v for bank one & two coils, 15 amp each +12v for bank one & two injectors, a few other power & grounds & it will run.
http://www.lt1swap.com/99-02_vortec_pcm.htm
#19
Ok it is now 2015 and this information is still useful :-)
have had the 5.3 in a '87 T-Top LS Monte Carlo and just getting to the A/C - it is important to run the A/C through the PCM to avoid over pressure and have A/C compressor clutch off at WOT. Thanks to all who posted here. going to upload some additional content because the wire descriptions are the same, but the pin location is different from 2000 and 2007 - 2008 to 2012 then again 2013 to 2017. LT1swap has a lot of good information there. People who buy ready made harnesses really miss out because when something goes wrong the intimate knowledge of how it all works is missing and then they are stuck. Kudos to all posting here.
have had the 5.3 in a '87 T-Top LS Monte Carlo and just getting to the A/C - it is important to run the A/C through the PCM to avoid over pressure and have A/C compressor clutch off at WOT. Thanks to all who posted here. going to upload some additional content because the wire descriptions are the same, but the pin location is different from 2000 and 2007 - 2008 to 2012 then again 2013 to 2017. LT1swap has a lot of good information there. People who buy ready made harnesses really miss out because when something goes wrong the intimate knowledge of how it all works is missing and then they are stuck. Kudos to all posting here.
Last edited by John McPherson; 06-20-2015 at 10:44 PM. Reason: clarification added