94'BLKBRD

iTrader: (76)

I installed an LED in my headlight switch. When I hooked it back up it and started the car it didn't turn on. So i fiddled with the connections(yes I'm a dumbass) while the car was on. So now some of my gauge cluster lights don't work. The SES, brake, etc work but the lights that light up the speedometer, rpm, water temp, oil pressure, volts and fuel level don't. The shifter light and the a/c lights don't work either.

I checked the fuses, they all seem to be good. What can it be? short?

ae13291

iTrader: (8)

do the radio lights still work? i would remove the gauge cluster first and check it out from there. btw u will have better luck in the general maintenance section

94'BLKBRD

iTrader: (76)

Everything works except the A/C lights/shifter lights/gauge cluster lights

ae13291

iTrader: (8)

my bad seems like they all link to one power source, i will check out the schematics in my haynes manual

94'BLKBRD

iTrader: (76)

I searched and found out someone had an identical problem. He fixed it by replacing his TAIL LPS fuse.

Could that be it?

ae13291

iTrader: (8)

^^ is that in the fuse block? i would have first suspected fuses but u said u checked em?

94'BLKBRD

iTrader: (76)

I don't even know where the TAIL LPS fuse is located. I searched and found out about that fuse.

ae13291

iTrader: (8)

its located inside on the drivers side fuse block

94'BLKBRD

iTrader: (76)

fixed it.......damn fuse tester was saying the IP Dimmer fuse was good when it was really blown

ae13291

iTrader: (8)

awesome