Ws6 Owners: Measure this for me
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: Nov 2004
Location: Michigan (Macomb or Lansing)
Posts: 1,653
Likes: 0
Received 0 Likes
on
0 Posts
Ws6 Owners: Measure this for me
I have a base T/A, I have a lot of goodies in it from slp so I got one of those chrome slp emblems I want to put in place of the ws6 emblem.
I want to get it as close to the ws6 spot as possible because that is so centered.
Can any ws6 owners make these 3 measurements for me?
1: Where the redline is, from the right edge of the "C" to the left edge of the W
2: Where the green dot is, from the bottom edge of the light to the top edge of the ws6 badge.
Edit: Can you also measure the length an the width of the ws6 badge along the middle axes?
I think it should look sweet when done.
I want to get it as close to the ws6 spot as possible because that is so centered.
Can any ws6 owners make these 3 measurements for me?
1: Where the redline is, from the right edge of the "C" to the left edge of the W
2: Where the green dot is, from the bottom edge of the light to the top edge of the ws6 badge.
Edit: Can you also measure the length an the width of the ws6 badge along the middle axes?
I think it should look sweet when done.