Car won't go into gear and strange noise
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Jun 2008
Location: Claremore OK
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Car won't go into gear and strange noise
Ok so driving today my car was not down shifting it felt like and was jerking when I would slow down so I kept having to put it in neutral to get it to stop then I would put it back in drive and it would work just fine. I checked the fluid and im good there. On my way home today I heard a strange rattling noise. I could only hear it at idle since my exhaust was to loud to hear it any other time. I get home start the car noise is gone. Put it in drive it immediately comes back put it in park goes away, drive comes back so I put it in reverse to back it out and nothing happens put it in drive nothing. Turn the car off then put it in reverse and it engages. So I play around with it some more and same thing strange noise that sounds about like a bolt in a dryer and trany won't engage. So what do you think? Converter has gone out? Flexplate?
#5
On The Tree
Thread Starter
iTrader: (4)
Join Date: Jun 2008
Location: Claremore OK
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Started on it today and should have it out by the end of the week I am just working a lot this week. Any other thoughts as to what it might be. I took it for a test drive today befor I started working on it and I went mabe a 1/4 mile and turned around and on the way back I almost didn't make it in the garage my RPM's were way up for how much power was being put down it felt like somewhere in the transfer I was looking a lot of power.