4l60e cooling lines
#1
Staging Lane
Thread Starter
Join Date: Jun 2006
Location: Columbia, PA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
4l60e cooling lines
hey guys, i have a new set of cooling lines for my 4l60e and i wanna replace the old ones cause the one line got a little close to the tensioner pulley and wore down a little. Anyway is there any special way of doing this. I have a 94 z28
#2
Oh boy. Are these like factory ordered, mandrel bent steel lines? If so, there is not easy way. Lots of bends, lot's of bad words.
I usually cut the line where it is compromised and the install a comprssion fitting type union. Works everytime.
g
I usually cut the line where it is compromised and the install a comprssion fitting type union. Works everytime.
g