Maggie
#1
Launching!
Thread Starter
Join Date: Dec 2011
Location: Jim thorpe, PA
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
Maggie
Looking to get a maggie wondering if a mp112 that was on a 2006 vette would fit a 2007 cts-v. both ls2's. what if anything would need to be modified. thanks
#2
TECH Fanatic
iTrader: (8)
Join Date: Jun 2010
Location: Helendale
Posts: 1,921
Likes: 0
Received 0 Likes
on
0 Posts
they wont fit...different pulley / belt system, different snout, and a couple other little bits that are different. you would wind up putting more money into it trying to get it to work, then just buying one built for the V1. the GTO is the only LS2 based engine that is similar to the V. it has an almost identical belt system.
if you are going to put something from a LS2 Vette on the V, might as well make it really worth it...like a TVS1900/2300.
if you are going to put something from a LS2 Vette on the V, might as well make it really worth it...like a TVS1900/2300.
#3
TECH Addict
iTrader: (14)
Join Date: Feb 2007
Location: Owasso, OK
Posts: 2,342
Likes: 0
Received 0 Likes
on
0 Posts
Coles statements are somewhat correct. Vette won't work because of the placement of the blowe on the manifold. Belt spacing is the same as the V. The GTO kit uses the same blower placement as the V with different belt spacing that does not work with the V. A switch GTO pulleys would be a must, or you can buy the V jackshaft and install it in the GTO. Fuel rails are also backwards on the GTO so you would need to swap rails from one side to the other and get the V fuel block if they are different.
#4
Coles statements are somewhat correct. Vette won't work because of the placement of the blowe on the manifold. Belt spacing is the same as the V. The GTO kit uses the same blower placement as the V with different belt spacing that does not work with the V. A switch GTO pulleys would be a must, or you can buy the V jackshaft and install it in the GTO. Fuel rails are also backwards on the GTO so you would need to swap rails from one side to the other and get the V fuel block if they are different.
How's the 2300 install coming along man?