I finally have my car back
08-16-2014, 11:22 AM
#1
On The Tree
Thread Starter
Join Date: Jun 2011
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
I finally have my car back I picked up my car yesterday afternoon. I put about 60 miles on it and it is what I expected. I ended up with a two piece G-force driveshaft. I can feel a ton more NVH because of the mounts/bushings. It feels like a different car. It feels old actually. Especially comparing it to my ATS. The good news is I launched it at about 2500 rpm and there is no wheel hop. I used to get massive wheel hop at 1500 rpm launch and on the 1-2 shift. I would have to let it roll and floor it in order to not have any wheel hop before. I haven't noticed any.
Overall I am happy with the way it turned out the only thing I wish for is that the NVH be the same as before. The guys at Speed INC did a great job with the install and if you are close to them I would suggest you contact them first. I think they were reasonably priced and they know what they are doing. From what I seen they do lots of V2's and the few times I went there they always had a different V2 wagon sitting on the driveway.
Overall I am happy with the way it turned out the only thing I wish for is that the NVH be the same as before. The guys at Speed INC did a great job with the install and if you are close to them I would suggest you contact them first. I think they were reasonably priced and they know what they are doing. From what I seen they do lots of V2's and the few times I went there they always had a different V2 wagon sitting on the driveway.
08-16-2014, 11:58 AM
#4
On The Tree
Thread Starter
Join Date: Jun 2011
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
Yup it's been there since May. Not their fault. Had a problem with DSS.
I did CS motor, trans, diff mount, Rev shift Cradle bushings, DSS axles, tune, and Gforce driveshaft.
