Bowtiedford

iTrader: (9)

I'm thinking about buying the Holley 300-132 intake, looks good and wondering how it would compare to the Victor Jr. There both close in dollars, Jr just a little higher.

The stunningman

iTrader: (47)

If the prices are close and hood clearance is NOT a issue, I'd just run the victor. I thought the Holley was a lot cheaper or at least though S-K speed. If you decide to run the holley I would get the paper felpro gaskets.

Bowtiedford

iTrader: (9)

I guess it is cheaper, 249 at jegs and 299 for the Jr. I might go with the Holley as its more in the rpm range for my motor. 2500 - 7000, ports are smaller 2.66 tall x .92 wide
Jr is 3500 -7500 ports are 2.74 tall x .98 wide heights are the same.
why the paper felpro gaskets?

The stunningman

iTrader: (47)

I wouldn't invest to much in the manufacturer RPM ranges. That's just my opinion on the gaskets. I'm sure you could use either.

Bowtiedford

iTrader: (9)

I do know RPM lol, I had a jr on my 302 Ford and it picked up when everybody said it was too much.

ZONES89RS

iTrader: (25)

All in the engine combination and cubes. A 6.0 will use a Vic jr sooner than a 4.8 but the 4.8 will get more RPM from it. Common knowledge I'm sure but I don't mind stating the obvious.