Ok I am new here but I have a question for everyone...
#1
Launching!
Thread Starter
iTrader: (10)
Join Date: Apr 2009
Location: Gilbert, AZ
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Ok I am new here but I have a question for everyone...
Ok so a buddy of mine has a 1997 Firehawk which has an LT4 in it with around 385 horses. He is swapping that out with a 6.2 corvette engine his friend is giving him. Now he is selling me the motor/tranny/suspension/rear-end/ECM/wire-harness etc.. for 5 grand which is a steal especially for the motor only having 27,000 miles on it.
Here is the kicker, I have 1995 3.4L V6 camaro.. Although his friend owns a shop and basically will do the swap, is there anything I should know before doing this or any complications I may run into, or am i good to go?
Here is the kicker, I have 1995 3.4L V6 camaro.. Although his friend owns a shop and basically will do the swap, is there anything I should know before doing this or any complications I may run into, or am i good to go?
#3
Launching!
Thread Starter
iTrader: (10)
Join Date: Apr 2009
Location: Gilbert, AZ
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Yeah it is... he is throwing in his friends 6.2L corvette motor which comes out of the 2008 Z51 I believe... im not sure but he basically said its the ZR1 motor without the supercharger so Im not sure if its the LS6 or not, im not current with the new LS motors
#5
Launching!
Thread Starter
iTrader: (10)
Join Date: Apr 2009
Location: Gilbert, AZ
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Yeah thanks I didnt know what was in it... but he also has a 93 cobra that he has sitting at 450 horse with 150 shot, he isnt worried about the motor... he basically wants to build my Camaro with it... I just dont know if i wanna make it all motor or S/C ready