When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Nice build. I'm looking at this thread and can't believe how much time has gone by since I sold you the subframe connectors that are on your WS-6. Time flies! Good work on the Camaro.
In the process of mocking up my through floor subframe connectors and roll cage just this last week. Did all the painstaking cuts for the subframe connectors and it looks good but can't wait to put the finishing touches on it to make it look great again!
Enjoy the pics
Bought some Wolfe Through Floor Subframe Connectors
Bought the Wolfe Racing 4 point roll cage
Pulling wiring out to take dash out.
Gutted
Dash out
Here we go !!!
The cut, this killed me haha.
Lining up, took a little while to get it perfect.
Tight fit with the roll cage mocked up.
Test fitting the cage with the one side done.
Driver's side's turn.
Snugs in there pretty damn well!
That's all I have for you guys this week!
Stay tuned
I know this is an older thread but I'm about to go through this with the SFC'S for my car. Honestly, it looks like the biggest pita job yet so if anyone old or new could throw out some pointers or help with some direction on making sure the cuts in the floor are in the right places I’d be grateful. I’ve had to email Wolfe hoping to get a correct part because it looks like two of my rear tubes are identical and they’re both marked for passenger side. Hopefully this can be resolved.
02-23-2017, 05:25 AM
