Almost there
#1
Launching!
Thread Starter
Join Date: Nov 2005
Location: Idaho (for now)
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Almost there
#4
Launching!
Thread Starter
Join Date: Nov 2005
Location: Idaho (for now)
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
I built a flat plate that bolted to the 6.0l block, then took the stock motor mount buckets and bolted them to the original mount in the frame - then I set the engine down - placed where I wanted the engine from front to rear - marked the buckets where they contacted the bolts on the flat plate - then cut around the bolts and welded the bucket to the flat plate. Sounds kind of busy, but it really wasn't - I've done many of these conversions and this was by far the easiest one yet, plus I retained the stock engine mount.