coolant crossover
#1
Teching In
Thread Starter
Join Date: Nov 2010
Location: michigan
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
coolant crossover
using fbody radiator and water pump... do I have to run the crossover tubes to the top of the water pump and drill/tap the housing or can i run a line from the crossover to the radiator just below the over flow outlet near radiator cap
also on the radiator there's a outlet in lower drivers side, what is that for can I just block that off
also on the radiator there's a outlet in lower drivers side, what is that for can I just block that off
#5
TECH Senior Member
iTrader: (12)
Soundengineering, what did you do to connect to the F-body radiator steam port ?...
If you have a late 4th Gen Radiator.. then I would just hook it up to the stock location on the Radiator.. you might need to adapte the different size port/hoses as they are different size on the radiator and crossover tube.
As other stated, either way will work (radiator or WP).
BC
If you have a late 4th Gen Radiator.. then I would just hook it up to the stock location on the Radiator.. you might need to adapte the different size port/hoses as they are different size on the radiator and crossover tube.
As other stated, either way will work (radiator or WP).
BC