ctd450

iTrader: (1)

Does anyone produce a MAF bung like this but in steel?



I searched quick and could only find aluminum bungs. I have steel tube for my intake, and no equipment to weld aluminum.

Looking to cut down on couplers and reducers, and build a simpler intake system for my race truck. Elbow on TB, 4" pipe, right to the air filter.

Thanks for the help!

fieroguru

iTrader: (1)

I just bent up some sheet metal, welded nuts on the inside, then welded it to the tube. Once the new section was made, I welded it to the old one so there is only 1 visible coupler.

ctd450

iTrader: (1)

Thanks, that doesn't look too hard. How did you make the square hole in the sheetmetal for the card to fit into? Did you use anything to seal it?

mille_3

iTrader: (1)

If you're ok with a plastic bung/adapter here's probably the easiest route

fieroguru

iTrader: (1)

I measured the body of the sensor, drilled a hole the width of the slot at both ends. Then used a file to square the ends up to the needed length.

The sensor comes with a rubber gasket to seal it.