Mech drawings or dimensions
01-09-2008, 10:09 AM
#1
Teching In
Thread Starter
Join Date: Dec 2007
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Mech drawings or dimensions Hi guys,
Newbie on this board with a question. I'm trying to adapt a SBC LC9 engine to my Land Rover Discovery 1 tranny. Reason is this; I love the SBC engine for re-power and have done several (S-10 truck, CJ5 and CJ7), but this one is a little different. What I'm looking for (and haven't found yet in all my searching) is some form of engineering drawing of the back of the LSX series engines that tells me where the locating pins and bolt holes are on the back of the block. If anyone has a pdf file or knows where I can go to find this out, I'd really appreciate this.
Regards,
Richard
Newbie on this board with a question. I'm trying to adapt a SBC LC9 engine to my Land Rover Discovery 1 tranny. Reason is this; I love the SBC engine for re-power and have done several (S-10 truck, CJ5 and CJ7), but this one is a little different. What I'm looking for (and haven't found yet in all my searching) is some form of engineering drawing of the back of the LSX series engines that tells me where the locating pins and bolt holes are on the back of the block. If anyone has a pdf file or knows where I can go to find this out, I'd really appreciate this.
Regards,
Richard
01-09-2008, 11:30 AM
#2
Richard,
The LSX and the GENI SBC use the same bolt pattern and pin locations (and diameters)with the exception that the LSX doesn't use one of the bolts (the one o'clock position when looking at the back of the motor). Basically, everything is the same. PM me if you need more info.
Andy1
The LSX and the GENI SBC use the same bolt pattern and pin locations (and diameters)with the exception that the LSX doesn't use one of the bolts (the one o'clock position when looking at the back of the motor). Basically, everything is the same. PM me if you need more info.
Andy1
