algws6

iTrader: (3)

will a bolt in 6 point pass tech?

ryarbrough

iTrader: (18)

If it's properly installed, has the harness bar welded in, and your car is slower than 135mph and no quicker than 10.0

sweetbmxrider

iTrader: (13)

the rear bars need to be welded to the main hoop as well as the harness/cross bar.

ryarbrough

iTrader: (18)

True... I thought I had that in there.

Both of those requirements are rarely enforced though, especially the one you mention.

algws6

iTrader: (3)

anyone know how **** they are at hrp?

gyrene2003

wolf 6pt bolt in cages any good? I was thinkin about getting one for the vert when i get back from afgan land?

94Z28rag

iTrader: (10)

Good if you only intend to need just a 6-point. I added on to my 6-pt Wolfe in my 'vert and it was a pain in the *** because the main hoop is about 2" lower than it should be. We had to make a "bump" in the driver's side to clear my head, and that's with a Kirkey mounted on the floor.

Villain281H

iTrader: (5)

A roll bar that bolts to the floor instead of welding will pass NHRA tech to 10.00/135 mph. Check the rules thread sticky at the top of this section.

Derek