Drag Racing Tech
Sponsored by:
Sponsored by:

In the process of dash removal....questions!

Thread Tools
 
Search this Thread
 
Old 05-05-2005, 09:22 PM
  #1  
TECH Addict
Thread Starter
iTrader: (123)
 
xssive's Avatar
 
Join Date: Nov 2001
Location: Austin, TX
Posts: 2,255
Likes: 0
Received 2 Likes on 2 Posts

Default In the process of dash removal....questions!

First, will having the hvac control harness disconned cause a vacuum leak or does it have a check valve in it?


Next, I have the 5 top screws of the dash out and the top is free. Where are all the other ones located?
Old 05-05-2005, 10:28 PM
  #2  
11 Second Club
iTrader: (14)
 
SUX2BU's Avatar
 
Join Date: Apr 2002
Location: DFW, TX
Posts: 3,267
Likes: 0
Received 1 Like on 1 Post

Default

First. Just cap off the little vacum line coming out of the back of the intake.

second, there are screws EVERYWHERE! the hardest one to find is actually inside the HVAC unit behind the right side of the ac controls.
Old 05-05-2005, 10:43 PM
  #3  
TECH Addict
Thread Starter
iTrader: (123)
 
xssive's Avatar
 
Join Date: Nov 2001
Location: Austin, TX
Posts: 2,255
Likes: 0
Received 2 Likes on 2 Posts

Default

Can I cap the two heater ports on the water pump or do I have to connect them?
Old 05-06-2005, 01:11 AM
  #4  
11 Second Club
iTrader: (14)
 
SUX2BU's Avatar
 
Join Date: Apr 2002
Location: DFW, TX
Posts: 3,267
Likes: 0
Received 1 Like on 1 Post

Default

cut a piece off the hoses going to the heater and loop the two ports. just make sure you use screw tighten hose clamps cause the ports are different sizes and the hose will slip off the smaller port if you use the stock hose clamps.




All times are GMT -5. The time now is 08:39 AM.