Hopes and Dreams
06-29-2008, 07:40 PM
#1
On The Tree
Thread Starter
iTrader: (15)
Join Date: Jan 2008
Location: N-D-Ana
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
Hopes and Dreams Hi guys, I am just curious if anyone could give me a ball park figure for what kind of power my motor might make. I am putting an LS1 into an RX7. I have stage 2 lloyd elliot heads (#842). I think they flow 330/260, and have comp dual springs and 2.05/1.59 valves. My cam is a custom ground comp, 230/240 duration, .609/.613 lift, and a 111 LSA. I am also running the edelbrock vic Jr. intake (which from the dynos I have seen is very close to an LS6 in flow. -1 ftlb down low and +1 hp up top). I will have truck coils and 1 3/4 LT, no cats and a borla bullet muffler. It will be going through an m6 trans. I was wondering if I would be dissapointed to look forward to 440 whp and 400 ftlb torque with a streetable powerband???
06-29-2008, 11:30 PM
#2
on a lower reading dynojet, I'd say around 420rwhp/390rwtq(just guessing), and could be a LOT lower on any severe dynojet or mustang dyno. Hell I didnt even break 400rwhp on MD mustang dyno, but cracked 405 on a lower reading dynojet. I might break 420rwhp on a cheesy dynojet...
Good luck with your numbers!
Good luck with your numbers!