Plastikk

I am looking for how others have mounted their intercooler systems. The more pictures the better. Please share your setups!


My build:
02 camaro
On3 setup

forcd ind

iTrader: (7)

here's how I mounted mine on my 72 chevelle-I orig had a Procharger sheet metal one, but it was to wide-this is a Treadstone one, thicker but 2" shorter
I welded a 90 deg on one end, snaked the pipes thru the core support
I was able to lower it to uncover some of the radiator, and keep the hood latch

forcd ind

iTrader: (7)

it was easier to mock it up on the core support off the car-I did a Procharger one on a 69 chevelle, it actually had more room than the 72 because of the grill design
I think a Camaro has a fair amount of room in front, cant remember

Camaro9969

iTrader: (12)

Tally TransAm

iTrader: (17)

used this setup on a few cars, cheap and easy

ws602

iTrader: (2)

I am useing the Burkhart front bumper support
Pm me your email and I will send you pictures

Plastikk

Is that something you fabricated or is that purchased?

Plastikk

Thank you for the pictures and input!

ws602

iTrader: (2)

Email sent

a98ws6

iTrader: (48)

Pm sent.

coolmanvette75

iTrader: (2)

I have custom mounts on mine that mount it right to where the factory bumper support bolts to...

JustAFooL

iTrader: (45)

It was fabricated. If you look at his build thread, him and his buddy both are extremely talented

Camaro9969

iTrader: (12)

Just fabbed up didn't cost more than 20 bucks and a little time to make.

Thanks man I appreciate the compliments

Plastikk

What is that front bumper support off of? The headlights look like a Camaro but what year. My 02 bumper support is different.

conan

iTrader: (5)

Just got some work done on my front mount today...
00 z28, d1 Procharger, CX racing 31" x 12" x 4" cooler and a Burkhart front bumper support.

Troy5061

iTrader: (19)

Heres mine.

JoshuaGrooms83

iTrader: (2)

least amount of cutting




then mounted the EMUSA 31x11x3 bar and plate intercooler.


then of course started running charge piping


while running the lling pipe, i ran the wastegate reference line and oil pump wiring


mind you mine is a rear mount so my pipe routing might be different then yours.

Tally TransAm

iTrader: (17)

its the stock bumper support with the center cutout to fit the intercooler. crossbar is just some square stock welded to the ends to hold the intercooler

35thsscamaro02

Taubr Unit

iTrader: (32)

heres mine.......