stevieturbo

At last they have arrived ( Even though I only ordered them last Tuesday lol )...no thanks to Fedex the *******, who normally I would praise. But anyway.

Thanks to Ron at Vengeance Racing for getting these Trickflow 225cc heads sorted for me. Unfortuantely Im awaiting some new pistons due to my sillyness.

At last some springs that might work. The springs on my Edelbrock were opening at around 100lbs when I measured them last ( before DIY shimming )
With the same tool, same method, these are closer to 150lbs....















Also needed different rockers ( well, non-stock rockers ) so it was a good time to dump my old YT's, in favour of some new ones.
There really is a huge difference between the two !!!



The Jesel 1.75's look as if they will fit a lot better on these heads, than the Edelbrocks I was using. So I could also consider that option, which along with a new cam, should see lift well into the 600's if I so decide. Probably isnt necessary though.



Its always nice to get new bits....

Now it's EPP's turn to send me some rings and their FI cam

Beaflag VonRathburg

iTrader: (176)

Edit: I don't know what I was reading.

kp

iTrader: (34)

Now I know who has the money, need new springs so just order a new set of heads

The new YTs look pretty good, I need to do aftermarket rockers one day..

stevieturbo

Money.......I can only dream. For everything else, there is Mastercard

May as well enjoy someone elses money. I could get hit by a bus tomorrow. Im not going to spend my entire life saving and having nothing, when I can enjoy it blowing money on stupid f**king cars lol.

Beaflag...I didnt post a pic of the Jesels.

But here is a pic I took a while back.

Got Me SOM

iTrader: (2)

very cool man, good luck on the new build.

kp

iTrader: (34)

ha, I dont see many people having huge savings accounts in the forced induction section - I sure dont But yea, do it while you are young and can enjoy it