PRAY HRD

iTrader: (119)

Hey guys, i just had my stock LS tank switched out to a metal LT F'body tank so it could be sumped and had already sold off the dual pump setup with my bucket so now i'm needing to mount a sending unit on the metal arms coming down from the hat on the LT pump mount. To do so i need to see how far down the LS equipped bucket that the float arm mounts so i can get it decently close and read my fuel level again. Sucks on E85 cuz it goes so quick and stations are very few and FAR between around here.

Anyway, just to recap, i need a pic of a 99-02 F'body bucket, the side that has the float attached to it, with a tape measure showing how far below the top that it's located.

Your help is Greatly appreciated!!

RacerXLs1

iTrader: (14)

Pm me your number I can get it tommorw

PRAY HRD

iTrader: (119)

never got your text. anyone else able to help me out with this please???

PRAY HRD

iTrader: (119)

Anyone at all? would REALLY like to know how much fuel i have in the tank.....

PRAY HRD

iTrader: (119)

1 more time requesting this......

Lonnies Performance

iTrader: (16)

You cannot get an accurate measurement from the top.... it compresses when you install it on a 99 tank.

You need to mount the level sensor so when the float arm is fully dropped, it is about 1/2" off the bottom of the tank.

PRAY HRD

iTrader: (119)

so THAT'S why they have springs on em! LOL ok well i'll go ahead and take that route then by measuring from the floor to the top of the tank and install it so it sits as you say. thank you very much!!!