anyone get lucky with stock shims
#1
On The Tree
Thread Starter
Join Date: Oct 2004
Location: Brady TX
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
anyone get lucky with stock shims
I am setting up my rear my car. I had my new bearings pressed on the carrier. After I got my pinion in and the preload set I threw the stock shims in and had a hell of a time getting the carrier in but finially it went in. For some reason it came out a lot easier than it went in. Anyway I torqued the cap bolts down and checked the backlash and it is .006. I was kinda of amazed that I got this with the stock shims. Just curious if anyone else thought this was strange?
Last edited by 99ss00ws6; 06-10-2005 at 10:37 PM.
#3
On The Tree
Thread Starter
Join Date: Oct 2004
Location: Brady TX
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by glennster
I came close on the 4.10 install into my 10 bolt,but not that close.pattern is way more important then backlash.