Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

BBK LT's ready to install how high

Thread Tools
 
Search this Thread
 
Old 03-03-2011, 09:14 AM
  #1  
Launching!
Thread Starter
iTrader: (8)
 
Z06 Steve's Avatar
 
Join Date: Feb 2005
Location: Albany,N.Y.
Posts: 268
Likes: 0
Received 0 Likes on 0 Posts

Default BBK LT's ready to install how high

I wanna know if a set of rhino ramps will give my 2000 Z28 enough lift for the install? Do the BBK's both install from the bottom?
Old 03-03-2011, 11:07 AM
  #2  
TECH Fanatic
iTrader: (8)
 
SWEET98SS's Avatar
 
Join Date: Dec 2002
Location: Syracuse, NY
Posts: 1,349
Likes: 0
Received 0 Likes on 0 Posts

Default

I did LPP long tubes, I had the car 16" high from the bottom of the side of the car to the floor. Im pretty sure they will install from the bottom. I also did my tranny at the same time so I had to have it this high to get the tranny out. I dont think ramps will be high enough.
Old 03-03-2011, 11:07 AM
  #3  
TECH Fanatic
iTrader: (20)
 
94Z28-MSTGKLR's Avatar
 
Join Date: Feb 2008
Location: Lacey, WA
Posts: 1,434
Likes: 0
Received 2 Likes on 2 Posts
Default

I doubt it will be high enough and yes they will both install from under the car.
Old 03-03-2011, 01:01 PM
  #4  
TECH Senior Member
iTrader: (35)
 
99Bluz28's Avatar
 
Join Date: Nov 2007
Location: C. V., Kalifornia
Posts: 9,705
Likes: 0
Received 11 Likes on 11 Posts
Default

If it's lowered NO, stock height maybe!Do you have some good jack stand that will take it a good 6" higher do that. Then jack up the rear of the car and put the ramps under the rear tires. That way it'll be easier to install the Y-pipe also.




All times are GMT -5. The time now is 07:47 AM.