speedracer1280

iTrader: (11)

what type of plastic is the fast 92mm made of ?... I have been searching and didnt find anything clear.

basically I have an intake that caught on fire for a few seconds.. just enough to put some small bubbles on top of the runners. they wont sand out. so I want to fill them with some type of filler, sand and paint..

thanks

southsidecox

iTrader: (11)

have you went to their website? should have info on that,you could also send them an email asking what they suggest

01ssreda4

iTrader: (96)

I would use a plastic body filler if its on the outside of the intake. Should work fine.

speedracer1280

iTrader: (11)

thanks guys.. ready to get this project rolling

studderin

iTrader: (28)

use a 2 part plastic epoxy.

the material is called Amodel, I think the LS1/6 were nylon 99, I forgot