ARH 1 7/8" with tsp duals
#1
TECH Apprentice
Thread Starter
iTrader: (16)
Join Date: Nov 2008
Location: illinois
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
ARH 1 7/8" with tsp duals
I searched and searched but could only find a few threads from 2009 that were not decisive on if they fit together or not. Not sure if anything has changed since then and Being 2013 now does anybody know if ARH 1 7/8 headers with fit with the TSP duals?
#2
I can help you make them fit if you would like. I have welded up a few custom exhaust systems for my car. Here are some pics of my last setup, full 3" duals with an X pipe.
#3
TECH Apprentice
Thread Starter
iTrader: (16)
Join Date: Nov 2008
Location: illinois
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
I will be finding out if it fits on Wednesday when it comes in. I figure it will be easier to get this to fit than fabbing a whole system myself. Luckily I have a "shop" at my disposal so I should not need the help but if I need it I will definitely get a hold of you, Thanks
#4
Ok, let me know. Also, I may have worded that wrong and made it sound like a sales pitch but that wasn't my intention. I just figured if I could help I should offer it to you since your in the area. Either way, please let me know how it goes, cause I just sold my exhaust and bought a set of ARH stepped headers earlier this week as well.
Trending Topics
#8
Okay where do i get this true duel setup!?? Ive bought 4 different exhaust & ripped them all off! Everyone ive tried sounds like glasspacks & i hate that redneck crackling sound... & also can i get this setup to work with my SLP headers??
#10
TECH Fanatic
Wanna make me the up and over the axle out the back part for my exhaust? I figured that is going to be very hard for me to do on my own. And I'll worry about mating it up to my current duals.
#13
TECH Apprentice
Thread Starter
iTrader: (16)
Join Date: Nov 2008
Location: illinois
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
Been working on it for the past couple hours. Got it really close with just shortening the drivers side part of the x along with the part that goes on the collector. Should have it done tomorrow.
#19
TECH Apprentice
Thread Starter
iTrader: (16)
Join Date: Nov 2008
Location: illinois
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
It is actually a lot quieter than I had thought it would be, the idle sounds smoother than before too. Overall I would say product quality is 7/10. welds were pretty ugly, i had to cut to make it fit (could be from the cross brands of parts) but I could not build one for this price, sound 9/10 was expecting louder.