Is this a doable exhaust?
#1
TECH Apprentice
Thread Starter
iTrader: (2)
Join Date: Mar 2004
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
Is this a doable exhaust?
I can't seem to get my exhaust right. I had LT's with an ORY into a borla and it was loud, but way too raspy. I then went to a catted y pipe to get rid of the rasp and then it got WAYYY to quiet! If I wanted to run cats (lots of mobile inspections coming up around me lately) Could I run cats, dynomax bullets into dumps? I'm assuming this would be louder than my current setup? (The same catted y pipe witih borla)
If this is possible, besides the cats and bullets, should I buy an X pipe or should I just let an exhaust shop fab up the whole setup? Is the sound difference of an H pipe worth the extra money to fab up? If I have cats do I even need bullets? Is the point of them just to add a better tone rather than 'quiet' it down?
If this is possible, besides the cats and bullets, should I buy an X pipe or should I just let an exhaust shop fab up the whole setup? Is the sound difference of an H pipe worth the extra money to fab up? If I have cats do I even need bullets? Is the point of them just to add a better tone rather than 'quiet' it down?
#3
TECH Regular
iTrader: (1)
Join Date: Dec 2004
Location: Toms River, NJ
Posts: 404
Likes: 0
Received 0 Likes
on
0 Posts
Ryan, pull your intermediate pipe off your Y and see how it sounds like that.
If you like the way it sounds stick with your setup and pickup an E-cutout.
If it's not loud enough, well, then think about the bullet/dumped route.
If you like the way it sounds stick with your setup and pickup an E-cutout.
If it's not loud enough, well, then think about the bullet/dumped route.