bad6as

iTrader: (17)

i have a 98 z28 with 95K and im gonna do a ls6 im swap on it soon. i read a couple post and they said it was a good idea to replace the 98 sensors with the newer sensors and harnes and table. but i also read that using the 98 sensors and a newer knock sensor table would do the same. what should i do?

bad6as

iTrader: (17)

any one?

35thUCF

no idea, I would look and see if they are rusty, i hear that water sits around their base and screws with them

bad6as

iTrader: (17)

yea, but i dont want to pull the intake then see if theres rust. any one else?

staringback05

iTrader: (8)

are you developing knock? have you had it on efi live? is it pulling timing or running like crap?...answer those you answer your ?