Tips on properly porting and resealing a FAST 92?
04-17-2008, 03:10 PM
#1
TECH Apprentice
Thread Starter
iTrader: (8)
Join Date: Dec 2005
Location: Morris, IL
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
Tips on properly porting and resealing a FAST 92? Any tips would be appreciated. I pulled my Fast apart only to realize that these gaskets are horrible. I notice Fast uses some kind of RTV in certain spots, I assume where two seals join.
Also, I smoothed the casting on the upper shell at the begining of the runner. I am not sure if I will port match, being that I don't know if I want to seperate the middle and lower shell now based on the seals... But what gets ported in this area if I don't port match? I would assume something being our sponsers offer ported one.
Also, I smoothed the casting on the upper shell at the begining of the runner. I am not sure if I will port match, being that I don't know if I want to seperate the middle and lower shell now based on the seals... But what gets ported in this area if I don't port match? I would assume something being our sponsers offer ported one.
