Edelbrock Stepped LS1 Headers...
#1
Launching!
Thread Starter
iTrader: (4)
Join Date: Aug 2002
Location: Alongwayfromhome
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Edelbrock Stepped LS1 Headers...
...get TWO THUMBS UP.
I bought the Ti coated variant. Box came yesterday. Important features:
1) Stepped 1 3/4 to 1 7/8 inch design.
2) Ti coated outside AND inside.
3) Hardware? Freaking ALL OF IT, including O2 extensions. Did I mention that they include O2 extensions?
4) Slip-fit merge collector included.
They'll go on the car shortly (next couple of weeks) as part of a much larger project, but I'd like to say that at this point they seem to be the best value out there.
Reasonably priced, ALL of the choice (merge collector) and necessary (O2 extensions and fasteners and gaskets, etc...) components are included.
When I start getting dyno results, I'll post 'em.
I bought the Ti coated variant. Box came yesterday. Important features:
1) Stepped 1 3/4 to 1 7/8 inch design.
2) Ti coated outside AND inside.
3) Hardware? Freaking ALL OF IT, including O2 extensions. Did I mention that they include O2 extensions?
4) Slip-fit merge collector included.
They'll go on the car shortly (next couple of weeks) as part of a much larger project, but I'd like to say that at this point they seem to be the best value out there.
Reasonably priced, ALL of the choice (merge collector) and necessary (O2 extensions and fasteners and gaskets, etc...) components are included.
When I start getting dyno results, I'll post 'em.