I found some 3 inch stainless, Help me out with duals
09-08-2003, 12:04 PM
#1
TECH Fanatic
Thread Starter
Join Date: Feb 2002
Location: Friendswood TX
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
I found some 3 inch stainless, Help me out with duals One of my friends gave me a 10 foot section of 3 inch stainless and I want to see if I can make some duals. I have coated hookers and a coated y so thats where ill get a pattern from. I was thinking that Ill take off my y-pipe to get an idea of how the pipe should come off the header. Also the y is clearenced from the factory. so that will also give me an idea on where to clearence it. So then I was thinking of getting a dr. gas X-pipe and then out to two 12 inch bullets, and turn downs of course. Any thoughts or ideas to help me out? or a better way to look at doing it?
09-08-2003, 12:09 PM
#2
TECH Junkie
Join Date: Apr 2003
Location: Houston, TX
Posts: 3,340
Likes: 0
Received 0 Likes
on
0 Posts
Re: I found some 3 inch stainless, Help me out with duals Sounds good to me-Ive heard good things about the Dr.Gas X pipe-I also have Hooker LT's(cermaic coated)and Hooker off-road Y-let me know if you go this way I would like to hear the Dr.Gas X and dual bullet muffs. 
