Sammyboy

iTrader: (9)

I have a Victor JR intake manifold and a Nitrous Outlet elbow including 3 bungs. The JR has a large diameter hole on the rear runner and a smaller nipple on the passenger side. The Nitrous outlet elbow has three bungs, one in the rear and two in the front. I was just confused about where all of my vacuum lines should connect and which hole they should connect to, most importantly my MAP sensor at the rear of the engine. For instillation purposes, I have a LS6 Valley cover which includes the integrated PCV with both valve covers pluged.

Sammyboy

iTrader: (9)

Help for the weekend!!

180ls1

iTrader: (4)

just call them. I am sure they would be more then happy to help you espically since you bought parts from them

Sammyboy

iTrader: (9)

I figured most of it out as far as hose fitting are conserned, but I wasn't sure what sized hole I would need for my map center located at the side of the vic jr?

z28mccrory

iTrader: (7)

I ran my brake booster off the rear port on the vic jr.

I used the small hole close to the "carb" flange on the passenger side for my MAP sensor and other vacume reference items (used a tee).

Z28/2002

iTrader: (27)

The small 1/8th inch hole just under the flange is where you need to run the MAP sensor hose