crane rocker arms
#1
TECH Enthusiast
Thread Starter
iTrader: (34)
Join Date: Aug 2006
Location: DFW
Posts: 612
Likes: 0
Received 0 Likes
on
0 Posts
crane rocker arms
Im going to be putting the crane 1.8 RR's on the trans am in the next week. I have springs and pushrods, but was reading that you needed a smaller pushrod? Any light on this would be nice. as of now I have stock length pushrods.
#2
TECH Enthusiast
iTrader: (16)
Join Date: Jun 2004
Location: Farmingville, New York
Posts: 586
Likes: 0
Received 0 Likes
on
0 Posts
I have the Crane 1.7's and I know the complete kit comes with the proper pushrods, guide plates and studs, as well as the rockers. I would give you the length, but they're packed away in the garage somewhere and I'm unable to walk due to a shattered femur. Also, I'm not sure the length would be the same between the 1.7's and 1.8's. The best thing to do is measure anyway.
#6
TECH Enthusiast
Thread Starter
iTrader: (34)
Join Date: Aug 2006
Location: DFW
Posts: 612
Likes: 0
Received 0 Likes
on
0 Posts
I'm going to keep the 1.8 rockers on the stock cam I saw the ki any all I really need is the rockers I have hardned 7.4 pushrods but just need to be sure so I don't mess anything up