MS3 and PRC 5.3 heads... Intake question?
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Aug 2007
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
MS3 and PRC 5.3 heads... Intake question?
I have an 2002 LS1 with MS3 cam and going to order a set of PRC 2.5 5.3 heads. Can I use my LS6 intake or will I be holding the motor back? Or should I get a FAST??
Also do I need injectors??
Thanks
Also do I need injectors??
Thanks
#3
Launching!
iTrader: (2)
Join Date: Nov 2008
Location: Vancouver, BC
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
You dont NEED a FAST intake, though bolting one on will certainly give gains.
Do a search in the Dyno comparison forum, theirs a few guys who have 420+ rwhp through a LS6 intake. Then guys who have 460+ with FAST intakes.
Do a search in the Dyno comparison forum, theirs a few guys who have 420+ rwhp through a LS6 intake. Then guys who have 460+ with FAST intakes.
#6
TECH Apprentice
iTrader: (6)
Join Date: Apr 2005
Location: Savannah, GA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
they didn't make any difference on the dyno. i just got a good deal on them so i put them on after the second pull which was 463 and he retuned with injectors and it was same. the dyno i was on is a stingy bastard. i put down 488rwhp on a different dyno jet. but of course i claim the lower one to be on the safe side.
but they never hurt b/c if you like me more mods are coming.
but they never hurt b/c if you like me more mods are coming.