CAT3

iTrader: (9)

Well, I battled some tuning issues early on, but with the help of WicketMike, got the infamous p0121 code taken care of which also got the trans issues solved. I was a little depressed, not because of the cam, but firmly believing my stock heads SUCK. I still do, but the other day, I found "tested" my car against my friends, and I began to walk him. We had to let off, but his car runs 10.8x with Stage 2 heads and TR224 cam. So, after chatting with Jason about what, other then my defunkt heads could cause me not to gain any mph or drop et, I am going to try and adjust shift points! *light goes on*

Often its the small things we forget, so will try this. Although they are set at 6500 now, the car shifts out of 1st at 5800-6000rpm, and 2nd at 6200rpm. So, will play around and get them to let out at 6700 or 6800. Hope it works better.

Just wanted to share.

Charlie.

SouthFL.02.SS

Yes. My setup peaks at 6250, but holds strong till 6700 on stock heads. You're leaving a lot of power on the table without going up high.

Y2KSS

iTrader: (2)

Charlie,
What did you do to get rid of the p0121 code. My car is setting this code too with this cam.

Thanks,
James