trey1010

iTrader: (3)

Hey everyone just re-installed my harmonic balancer. There is still a littl gap between the balancer and the front engine cover. I was thinking It needs to be up against it but the belt stays on well good. Anyone have any pictures of jon close it should be ?

Damian

iTrader: (89)

Pulleys are not seated by how close they look to the block. They're seated according to a 250ft lb TQ spec.

So when the TQ wrench clicks on 250, that's what it's suppose to "look" like.

NVR_SPDS

iTrader: (39)

Like damian said, if its torqued, your good.. it shouldnt contact the front cover. the part that seals sits inside the cover.

99Bluz28

iTrader: (35)

As long as it's within this range you good!